Holley rebuild manual

MANUAL CHOKE MODELS: A. Connect the choke control cable (Holley P/N ) to the choke actuation lever, and lock in place with the choke cable lock screw. B. Mount the outer sleeve to the cable clamp. C. Actuate the choke cable through its full range of motion to ensure full choke operation. Adjust as necessary.  · Rebuild and Adjustment Manual for Models , , , , , , , , and Rest the carburetor on a repair stand to avoid damage to the throttle plates during renewal procedures. Use the exploded view, for the model of Holley® Performance Products Russellville Road Bowling Green, KY NOTE: Please see the enclosed instruction manual for complete removal, installation, and tuning instructions. 1. Place the new carburetor flange gasket, provided with the carburetor, in the proper position on the intake manifold. 2. Place the carburetor on top .

Homepage - Mikes Carburetor Parts. Simply pry the face up with a fingernail and pull/wiggle it loose. If you tear the valve's nipple in the process, replace it with a new valve from a Holley rebuild kit. The check valve's nipple has a radiused barb tip that secures the valve in the bowl. Step 7: Inspect Accelerator Pump Cam (Critical Inspection). Most Holley carbs with a choke use either a mechanical or an electric choke. The mechanical choke is controlled directly by the driver via a cable. The electric choke is fitted with a thermostatic spring inside a housing; careful adjustment provides dependable cold-engine starts. Manual Choke Installation Step 1: Install Choke Housing.

Rev 02/14/20 www.doorway.ru Page 1 of 12 Technical Support () Installation instructions Part No. Competition/Plus® Shifter. Rebuild Kit. NOTE: Please see the enclosed instruction manual for complete removal, installation, and tuning instructions. 1. Place the new carburetor flange gasket, provided with the carburetor, in the proper position on the intake manifold. 2. Place the carburetor on top of the flange gasket on the manifold. MANUAL CHOKE MODELS: A. Connect the choke control cable (Holley® P/N ) to the choke actuation lever, and lock in place with the choke cable lock screw. B. Mount the outer sleeve to the cable clamp. C. Actuate the choke cable through its full range of motion to ensure full choke operation. Adjust as necessary.